BETTER TOUCH BETTER BUSINESS
Contact Sales at ZYZM zipper machine manufacturer.
ZYZM Zipper Machine Manufacturer-One Stop Solution Service Provider for all kind of Zipper Making Machines.
The zipper machine is produced by advanced technology at home and abroad. It is a new product for horizontal conveying of powder, granular and small block materials. Because of our reasonable design, novel structure and long service life, Its performance is obviously better than that of screw conveyors, buried scraper conveyors and other conveying equipment, so the products are well received by users.u200b
1. Guarantee the negative pressure of the casing
Ensure the negative pressure in the casing, which seems to be an environmental protection problem, but is actually closely related to the problem with the material. If there is a certain negative pressure inside, the dust will not easily fall on the chain or rail, and the problem of carrying material will be alleviated to a certain extent. u200b
2. Change the feeding form and reduce the belt material
The feeding form of the zipper machine is divided into side feeding and upper feeding. The upper part is fed, and the material falling on the chain and rail will be taken away, and the carried material will be scattered halfway, and will also be brought to the tail of the machine. The treatment method is to change to side feeding or double side feeding to avoid the material falling on the track and chain. If the upper part of the material must be fed, the upper rail can be cut 500mm away from the feed port. The end is folded down at about 30 degrees to avoid the impact of the chain and the rail, so that the chain will vibrate here and force the material to fall.
3. Lengthen and widen the discharge chute
If the width of the discharge chute is smaller than the width of the casing, then the steps generated by it must be aggregated, and when the chain travels, the material will be taken with it. To the back, it will cause mixing; if the feeding slide is too short, part of the material will easily go over the feeding opening. Even if the track is cut off, the vibration will be small, so that the material carrying chain will continue to move forward.
4. Cut off the track at the feeding port
When the chain pulls the material to the feeding port, most of the materials fall into the warehouse, but some materials are still stagnant On rails and chains, it will be pulled back if left untreated. At this time, the rail at the feeding port can be cut by 200mm, forcing the chain to shake there, so that the material on the rail loses its support and falls completely. At the same time, because there is no rail here, the chain must vibrate here. , the material on the chain will be scattered.5. No steps are left at the final discharge end
Because some zipper machines do not conform to the process, there is still a certain distance between the final discharge place and the machine head, and a little material is often brought to the machine head; Although the material opening is at the lower part of the machine head, the opening of the lower casing is not opened outside the radius of rotation of the sprocket, which also causes the material to be aggregated at the step. Therefore, the opening position and size of the unloading slide are also critical and must be paid attention to.
We are here to help you! If you close the chatbox, you will automatically receive a response from us via email. Please be sure to leave your contact details so that we can better assist